3 Tier Tray Mould Set | 6, 8 & 10 Inch | 5mm Deep | Set of 3 - Cake Stand

Build a three tier resin display stand with this 3 tier tray mould set. The set has three round tray moulds with a scalloped edge, 6, 8 and 10 Inch (15.2, 20.3 and 25.4cm) across and 5mm (0.2 inch) deep, in flexible white silicone that peels away from the cured trays. Cast one tray in each mould with epoxy resin, then fit the three tiers to a stand for jewellery, perfume, candles or party table decor.

Specifications

Perfect for

• Three tier display stands for jewellery, perfume or candles
• Party and wedding table decor
• Ocean, marble and pressed flower pours
• Single round trays used on their own
• Small business resin gift sets

Compatibility

Works with: epoxy resin.

Pairs well with: mica powder, alcohol ink, gilding flakes and pressed flowers.

Not suitable for: sharp tools or cutters inside the cavity, which can tear the silicone.

How to Use

1. Set each mould on a flat, level surface and check it is clean and dry.
2. Mix epoxy resin and hardener in the ratio your resin maker gives, stirring slowly to limit bubbles.
3. Pour each mould to the same 5mm depth so the three tiers match.
4. Pop surface bubbles, cover against dust and leave to cure for the full time your resin maker states.
5. Flex the silicone away from the edge and ease each tray out before fitting it to a stand.

Before You Buy

• Resin, pigments, tools and the stand fitting are sold separately; the fittings and cakes in the photos are for display only.
• We state no food grade rating for this mould set, so use the cured trays for display rather than to serve food.
• Near twin: the 9x12 Inch rectangle tray mould makes one rectangle tray 10mm deep; this set makes three round tiers 5mm deep.

You will Need

• Epoxy resin and hardener
• Mixing cups and stirring sticks
• A three tier stand fitting

You may also like

• round moulds
• resin tray moulds
• gilding flakes and foil

Frequently Asked Questions

What sizes come in the 3 tier tray mould set?
You get three round moulds, 6, 8 and 10 Inch (15.2, 20.3 and 25.4cm) across, each 5mm (0.2 inch) deep.

How is this different from a single tray mould?
This listing is the set of 3 round tiers at 5mm deep; a single tray mould such as the 9x12 Inch rectangle tray mould makes one tray 10mm deep.

Does the stand fitting come with the set?
No. The set is the three silicone moulds only; the rods and handle in the photos are not included.

Should I use epoxy resin or UV resin for these trays?
Epoxy resin is mixed from resin and hardener and cures in the air over the time its maker states, so it suits wide pours like these trays. UV resin cures under a UV lamp in thin layers, so it suits small pieces or a thin top coat. Pick epoxy resin for the tiers.