3D Flower Tealight Holder Mould | 102mm | Design 2 | 25mm Deep - Resin

Cast a full bloom with broad layered petals around a sunken tealight well, the fuller of the two flower holders in this range. The white silicone mould is 102x25mm (4.0x1.0 inch). Pour resin, cement or plaster for a floral holder that looks carved.

Specifications

Perfect for

• Tealight holders for pooja and festive tables
• Dark cement holders with a gold rub
• Wedding decor
• Gift sets of three

Compatibility

Works with: epoxy resin, plaster of Paris, cement, jesmonite, candle wax and melt and pour soap base.

Pairs well with: mica powder, dried flowers and tealights in their own metal cups.

Not suitable for: food or oven use, since we state no food grade or heat rating for this mould; a bare flame on a resin cast, so keep each tealight in its cup.

How to Use

1. Wash and dry the mould, then set it level on a flat board.
2. Mix your resin, cement or plaster as its maker directs and pour slowly, tapping the sides to lift bubbles.
3. Leave it to cure fully for the time the maker states; an early release tears edges.
4. Flex the silicone back from one side and lift the piece out.

Before You Buy

• Mould only; resin, cement, wax and pigment are sold separately.
• The mould is white silicone; coloured pieces in the photos are example casts.
• The Design 1 flower mould is the same 102mm size with many narrow pointed petals; this one has fewer, broader petals.
• The maker chart in the photos is not a food or heat rating from us; keep the mould for craft casting.

You will Need

• epoxy resin and hardener
• casting and moulding powder

You may also like

• tealight candle holders
• mica powder
• candle making studio

Frequently Asked Questions

How big is the Design 2 holder?
The mould is 102mm across and 25mm deep, so the holder comes out about 102x25mm (4.0x1.0 inch).

How is Design 2 different from the pointed petal flower mould?
Both are 102mm across and 25mm deep. Design 2 has broad layered petals; the other has narrow pointed petals.

Can I cast cement and jesmonite in it as well as resin?
Yes. It is listed for resin, plaster, cement, jesmonite, wax and soap base; seal cement before wax touches it.

Mould or a ready made tealight holder, which should I pick?
A ready made metal or glass holder works straight away. This mould casts as many holders as you like in your own colours after a full cure. Pick the mould for batches, a ready holder for one piece now.