Adjustable Resin Ring Bezel | 5.2x7.2mm Teardrop Cup | Gold - Ring Base

Make a finished statement ring at home. This gold tone adjustable ring carries a 5.2 x 7.2 mm teardrop cup on top, a pear outline with a soft point at the top. The cup has a solid base and a raised rim, so you pour resin straight in, press clay into it or glue a cabochon down, with no taping and no leaks. The open band bends by hand to fit most fingers.

Specifications

Perfect for

• Resin rings poured and cured at home
• Single petal and droplet designs where the point gives direction
• Cabochon and flatback stone settings, glued in with a strong jewellery glue
• Polymer and air-dry clay rings, and small batch handmade jewellery

Compatibility

Works with: UV resin, epoxy resin, polymer clay, air-dry clay, dried and pressed flowers, glitter, mica powder, and any flat backed cabochon that fits inside 5.2 x 7.2 mm.

Pairs well with: matching bracelet and pendant bezels for a set.

Not suitable for: oven baking, because no heat rating is given for the plating. Bake polymer clay separately and glue it in once cool. It also will not hold a stone wider than the inside size above.

Before You Buy

• This is a closed cup with a solid base, not an open frame. You do not need to tape the back before pouring.
• The size given is the inside of the cup, so match your stone or fill to 5.2 x 7.2 mm.
• Resin, clay, stones and fillers are not included. This is the ring base only.
• No plating thickness or metal composition is stated by the supplier, so we state none.

How to Use

1. Wipe the cup clean so nothing sits under your fill.
2. Pour a thin first layer of resin, or press in clay, or run glue across the base for a cabochon.
3. Place flowers, glitter or foil into the wet layer.
4. Top up to just above the rim so the resin domes, then cure fully.
5. Bend the open band gently by hand to fit the finger.

You may also like

• UV resin
• dried flowers
• mica powder
• bracelet bezels

Frequently Asked Questions

Is the bezel an open frame or a closed cup?
A closed cup. It has a solid base and a raised rim, and the inside measures 5.2 x 7.2 mm, so resin stays put with no taping.

How is this different from the other sizes and shapes?
The teardrop is a pear outline with a point at one end. The eye cup is a longer pointed marquise and the round is a plain circle.

Will it fit my finger, and can I use UV resin?
The band is open and adjustable, so you bend it to size by hand. UV resin, epoxy resin and clay all work in the cup.