Neodymium Pot Magnet with Hook | 25 mm | 20 kg | Pack of 1 - Hanging & Lifting

A heavy-duty neodymium pot magnet with a detachable hook. The 25 mm base is rated to hold up to 20 kg on clean, flat steel, built for hanging, lifting and mounting in workshops, garages, sites and warehouses, and popular for magnet fishing, retrieval and rigging lights, tools and signage.

Specifications

Perfect for

• Hanging tools, lights, signage and fixtures on steel
• Lifting, holding and retrieval in workshops and garages
• Factory, site and warehouse mounting
• Magnet fishing and metal recovery
• Studio, event and display rigging

Compatibility

Works with: clean, flat, thick steel and iron. The pot design concentrates the pull downward for a strong hold.

Not suitable for: overhead lifting of people or safety-critical loads, and thin, painted, rusty or uneven surfaces, where the real hold is much lower than the rated figure.

Safety: this is a strong magnet. Slide magnets apart rather than pulling, they are brittle and can chip, and they are not waterproof so they can rust if left wet. Keep away from young children and pets as swallowing magnets is dangerous, and keep clear of pacemakers, electronics, cards and drives.

How to Use

1. Place the magnet base flat on clean, bare steel.
2. Attach the hook and hang your load within the rated limit.
3. To remove, slide the magnet to the edge and off rather than pulling straight out.

You may also like

• more craft magnets
• ferrite magnets
• magnetic sheets

Frequently Asked Questions

How much can it hold?
Up to 20 kg on clean, flat, thick steel. On thin, painted, rusty or uneven surfaces the hold is lower, so keep a safe margin.

Is the hook removable?
Yes, the hook is detachable with a 11 mm ring.

What is it used for?
Hanging and lifting on steel, workshop and site mounting, magnet fishing and retrieval.

Is it safe?
It is a very strong magnet. Keep fingers clear, do not use for overhead or safety-critical lifting, and keep away from pacemakers and electronics.