Self-Adhesive Cork Sheet Roll | 1mm Thick | 15x18 Inch - Pinboards

Turn a wall, a board or a drawer into a cork surface with this self-adhesive cork sheet roll. The sheet is 1mm thick and 15x18 Inch (38.1x45.7cm), natural cork with small coloured flecks, with a sticker backing under a peel off liner so it sticks down without glue.

Specifications

Perfect for

• Facing a notice board or a pinboard
• Lining drawers and shelves
• Cut shapes for cards, school projects and display boards
• Cork faced coasters and mats on an MDF base
• Covering a wall patch for notes and photos

Compatibility

Works with: clean, dry, flat surfaces such as MDF, wood, painted walls, card and plastic.

Pairs well with: MDF boards, push pins, craft knives and steel rules.

Not suitable for: damp or outdoor surfaces, or rough and dusty walls where the sticker backing cannot grip.

How to Use

1. Clean and dry the surface and cut the sheet to size with a craft knife against a steel rule.
2. Peel back a few centimetres of liner, line up one edge and press it down.
3. Pull the liner away slowly as you smooth the sheet from the centre out to push out air.
4. Press firmly over the whole sheet and trim any overhang.

Before You Buy

• At 1mm thick this is a thin facing sheet. For a pinboard, stick it onto a board so the pins have something behind them to hold.
• The sheet shows small coloured flecks through the cork, as in the photos.
• The roll arrives curled. Lay it flat under a weight before you stick it down.

You will Need

• MDF boards
• craft scissors

You may also like

• cork sheets
• school project supplies
• mounting and craft tapes

Frequently Asked Questions

How thick is this cork sheet and what size is it?
It is 1mm thick and 15x18 Inch (38.1x45.7cm), supplied as 1 roll with a sticker backing.

Do I need glue to fix it?
No. Peel the liner and press it onto a clean, dry, flat surface. Use craft glue only on a surface the sticker will not grip.

Will pins hold in it?
On its own a 1mm sheet is thin, so stick it onto an MDF board or a wall first. The board behind gives pins their hold.

Should I pick this cork sheet or an MDF board?
An MDF board is a rigid panel for painting and cutting shapes. This cork is a 1mm flexible sheet with a sticky back, made to face a board, a wall or a drawer. Many pinboards use both, cork on top of MDF.