Vintage Pedestal Tealight Holder Mould | 2 Part | Pack of 1 - Resin

Cast a footed pedestal holder that lifts a tealight off the table and reads as vintage glassware in tinted resin. The white silicone mould comes in two parts: a scalloped bowl 70x32mm (2.8x1.3 inch) and a fluted foot 71x41mm (2.8x1.6 inch). Pour resin, cement or plaster and join the parts once cured.

Specifications

Perfect for

• Rainbow resin tealight goblets
• Wedding and party tables
• Shelf decor with books and vases
• Gift sets of four

Compatibility

Works with: epoxy resin, plaster of Paris, cement, jesmonite, candle wax and melt and pour soap base.

Pairs well with: mica powder, dried flowers and tealights in their own metal cups.

Not suitable for: food or oven use, since we state no food grade or heat rating for this mould; a bare flame on a resin cast, so keep each tealight in its cup.

How to Use

1. Wash and dry the mould, then set it level on a flat board.
2. Mix your resin, cement or plaster as its maker directs and pour slowly, tapping the sides to lift bubbles.
3. Leave it to cure fully for the time the maker states; an early release tears edges.
4. Flex the silicone back from one side and lift the piece out.

Before You Buy

• Mould only; resin, cement, wax and pigment are sold separately.
• The mould is white silicone; coloured pieces in the photos are example casts.
• The photos show the mould in two parts, a bowl and a foot; join them with a little resin once both have cured.
• The Faceted Ball Tealight Holder mould sits flat at 8.8cm; this one stands on a fluted foot.

You will Need

• epoxy resin and hardener
• casting and moulding powder

You may also like

• tealight candle holders
• mica powder
• candle making studio

Frequently Asked Questions

What sizes are the two parts?
The bowl part is 70x32mm (2.8x1.3 inch) and the foot part is 71x41mm (2.8x1.6 inch).

How is this different from the Faceted Ball Tealight Holder mould?
This casts a footed holder in two parts, about 70mm across. The Faceted Ball casts one flat sitting holder at 8.8cm.

Can I cast cement and jesmonite in it as well as resin?
Yes. It is listed for resin, plaster, cement, jesmonite, wax and soap base; seal cement before wax touches it.

Mould or a ready made tealight holder, which should I pick?
A ready made metal or glass holder works straight away. This mould casts as many holders as you like in your own colours after a full cure. Pick the mould for batches, a ready holder for one piece now.