Clock Movement | 22mm Spindle | Max 11mm Board | Pack of 1 - Clocks

Give a medium thick clock board a steady tick with this quartz movement. Its 22mm spindle fits boards up to 11mm thick, it takes hands with a 5.1mm hour hole and it runs on one AA battery, not included. The spindle is the threaded shaft at the front; it has to pass through your board and still show a little thread for the nut.

Specifications

Perfect for

• Resin clocks around 8 to 10mm thick
• Clocks on 9mm or 10mm MDF boards
• Painted and Lippan art wall clocks
• Wooden plaque clocks

Compatibility

Works with: standard clock hands with a 5.1mm hour hole and a 3.3mm oblong minute hole, on boards up to 11mm thick.

Pairs well with: clock hands, a clock number ring and a hanger hook.

Not suitable for: boards outside the up to 11mm range, or minute hands longer than about 150mm.

How to Use

1. Measure your board, including any dial sheet or backing, and check it is up to 11mm.
2. Take off the nut and washer; slip on a hanger hook if you use one.
3. Push the shaft through the centre hole from the back, put the washer on at the front and tighten the nut until the movement sits firmly.
4. Point every hand at 12 as you fit it: hour hand first, then minute, then second.
5. Put in one AA battery and set the time with the knob on the back.

Before You Buy

• Hands and the AA battery are not included.
• Near twin: the 28mm spindle movement suits boards up to 17mm; the 18mm one suits 3 to 7mm.

You will Need

• clock hands with a 5.1mm hour hole
• One AA battery
• A clock base, see clock bases
• A hanger, see clock accessories

You may also like

• pre marked mdf
• lippan art materials
• mdf clock bases

Frequently Asked Questions

What board thickness does the 22mm movement fit?
Boards up to 11mm thick. That leaves enough thread at the front for the washer and nut.

Can I use any clock hands with it?
Standard quartz clock hands with a 5.1mm hour hole and a 3.3mm oblong minute hole fit. Check the hole size on the hands before you buy.

Should I buy the 22mm or the 18mm movement?
Use the 18mm movement for boards 3 to 7mm thick. Use this 22mm one when your board is thicker, up to 11mm.

How is this different from a clock movement kit?
The kits add 3 hands, 12 bar markers and a hanger hook to the movement, washer and nut you get here.